Made some changes to the front section of the leaf springs . added a 1/2 leaf on top of the main leaf . and clamps that fit inside the spring relocation front mount . also a lowering block to bring the rear of the car down . I have found that if the rear is to high to start with,  I don't get good weight transfer.

I plan on putting a pice of tubing  on each side that goes from where the cross bar intersects on the main hoop down to the rear frame where the front spring eye mounts

Put front spring eye bolt in bottom hole have not run the car with this setup

 Aeromotiv 150 pump and 1/2 fule line. the Aeromotiv &  Holley regulator only have a 7/32 hole at the inlet so I am looking to up grade that allso

put second battery in car, took it out better 60 foots

 lowerd front spring eye 1" and changed pinion angle from 10* to 6* nose down